Maintenance And Inspection - Makita MW001G Instruction Manual

NOTICE:
The appliance should be cleaned reg-
ularly and any food deposits removed. Failure to
keep the appliance clean may lead to deterioration of
the surface that could adversely affect the life of the
appliance.
NOTICE:
When cleaning surfaces of door and
oven that comes together on closing the door,
use only mild, nonabrasive soaps, or detergents
applied with a sponge or soft cloth. Never use
abrasive powder or metal brush to clean any part
of the appliance.
After use, wipe the oven door mesh with a damp cloth,
followed by dry cloth to remove any food splashes and
grease. Built-up grease may overheat and begin to
cause smoke or catch fire.
When the appliance has been used for a long time,
there may be some strange odors exist in oven.
Following 3 methods can get rid of them:
1. Place several lemon slices in a cup, then heat with
500W for 2-3 minutes.
2. Place a cup of red tea in oven, then heat with
500W.
3. Place some orange peel in oven, and then heat
them with 500W for 1 minute.
How to clean the sponge filter:
Clean the filter as shown below. The frequency of clean-
ing is once a month.
1. Open the filter cover. Remove the sponge filter
and take off the dust.
2. Wipe the surface and inside of the filter cover with
a cleaning cloth.
3. Wash the sponge filter in water and dry well or
blow out the sundries and dust adsorbed in the
sponge filter with an air duct. When the sponge
filter is damaged and cannot be cleaned, replace
the sponge filter in time.
Fig.7
► 1 . Filter cover 2. Sponge filter
Storage
When the appliance is not used, place the appliance
indoor and ventilated area.
2
1
10 ENGLISH
MAINTENANCE and
INSPECTION
MAINTENANCE
WARNING:
MICROWAVE RADIATION
Remove the battery cartridge before maintenance.
There is microwave radiation and high voltage in
the microwave. The high-voltage capacitor still has
dangerous voltage within 30 seconds after the power
is cut off. It is necessary to use a tool with insulating
handle to short-circuit and discharge the capacitor
terminal with the shell. It is strictly prohibited to
disassemble and repair by yourself except the
maintenance technicians to avoid injury to human
body.
CAUTION:
Always be sure that the appliance
is switched off, unplugged, and the battery car-
tridge is removed before attempting to perform
inspection or maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
ERROR CODE
When the appliance detects a fault, the control panel
displays the corresponding fault code as follows:
Error code
F01 The appliance is placed over 30 degrees
from level angle.
Check whether the appliance is placed
horizontally.
F02 Overcurrent.
Shut down and restart after replacing the
battery.
F03 Overvoltage.
Shut down and restart after replacing the
battery.
F04 Over-temperature.
Let the appliance stand for a period of
time and restart the appliance after it cools
down.
F09 Over-temperature.
Refer the section for the door opening and
closing protection function.
Error codes other Turn off and restart the appliance.
than the above
If the error still does not improve, take the appliance to
Makita Authorized or Factory Service Centers.
SERVICING
Check the appliance working correctly or not by
following:
Place one glass cup of water (approx.150ml) in the
Matter