Installation - Makita MW001G Instruction Manual

volts
direct current
Warning: Hot surface. Risk of burns. Do not
touch until cooled.
PREPARATION
CAUTION:
Always be sure that the appli-
ance is switched off and the battery cartridge is
removed before adjusting or checking function on
the appliance.

INSTALLATION

WARNING:
Install or locate this appliance
only in accordance with the provided installation
instructions.
1. Take out all the packing. Check carefully for dam-
age. If any, immediately notify dealer or send to the
manufacturer's service center.
2.
Place the appliance.
• Microwave ovens must be placed under dry and
non-corrosiveness environments, kept away from heat
and humidity, such as gas burner or water tank.
• To ensure sufficient ventilation, the distance of the
back of microwave to the wall should be at least 10 cm,
the side to the wall should be at least 2 cm.
• The position of the oven shall be such that it is far
from the TV, Radio or antenna as picture disturbance,
or noise may occur. The distance should be more than
2 m.
• To raise the handle, we recommend to keep the
free distance above the top surface at least 10 cm.
• The microwave oven must not be operated in
enclosed spaces such as cabinet. The microwave oven
is intended to be used freestanding.
2cm
10cm
2cm
Fig.3
NOTE: When using the appliance for the first
time, the appliance may smell the odor or a slight
smoke. The cause is manufacturing residue or oil
remained on the cavity or heat element. It is nor-
mal case and will go away after several times use.
Keep the door or window open to ensure good
ventilation. It is strongly recommended to place
a cup of water in the cavity, setting at 500W and
operate for several times.
Battery cartridge
Indicating the remaining battery
capacity
Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for a few seconds.
Fig.4
► 1 . Indicator lamps 2. Check button
6 ENGLISH
10cm
10cm
2cm
2cm
1
10cm
2