Makita MW001G Instruction Manual page 5

18. Keep the battery away from children.
SAVE THESE INSTRUCTIONS.
CAUTION:
Only use genuine Makita batteries.
Use of non-genuine Makita batteries, or batteries that
have been altered, may result in the battery bursting
causing fires, personal injury and damage. It will also
void the Makita warranty for the Makita appliance and
charger.
Tips for maintaining maximum
battery life
Charge the battery cartridge before completely
1.
discharged. Always stop appliance operation
and charge the battery cartridge when you
notice less appliance power.
Never recharge a fully charged battery car-
2.
tridge. Overcharging shortens the battery
service life.
Charge the battery cartridge with room tem-
3.
perature at 10 °C - 40 °C (50 °F - 104 °F). Let
a hot battery cartridge cool down before
charging it.
4. When not using the battery cartridge, remove
it from the appliance or the charger.
Charge the battery cartridge if you do not use
5.
it for a long period (more than six months).
PARTS DESCRIPTION
4
5
6
7
8
Fig.1
1. Handle
2. Control panel
Refer the following description for detail.
3. Cavity
4. Door
The appliance must be operated with the door
closed.
5. Oven door mesh
6. Cover of the USB port
7. Filter cover
8. Battery terminal
Control panel
1
Fig.2
1. Power switch
Power selection
2.
3. Microwave power
4. Operating time / Error code
5. Battery indicator
6. Pause/Stop
Time adjustment
7.
8. Start
VOICE GUIDE
• Heating end tone:
1
— 2 seconds of beep sound. If the door is
opened within 2 seconds, the sound is
2
silenced.
— When there is no operation, "beep, beep,
beep" (once every 1 second) sounds every 1
3
minute.
— Three minutes after, the appliance turns off
without any sounds.
Battery depletion prompt tone:
•
"Beep, beep, beep", "beep, beep, beep", "beep,
beep, beep".
When the error code is displayed:
•
A short, one "beep".
Quiet mode
After power on, long press the "STOP" and "START"
buttons at the same time until "OFF" is displayed to
enter the quiet mode. All prompt tones are turned off.
In the quiet mode, long press the "STOP" and "START"
buttons at the same time until "ON" is displayed to exit
the quiet mode. All prompt tones are restored.
ERROR CODE
When the appliance detects a fault, the control panel
will display the corresponding error code. Refer the
section for error code.
Symbols
The followings show the symbols which may be used
for the equipment. Be sure that you understand their
meaning before use.
5 ENGLISH
2 3 4 5 6 7 8