Table of Contents
Advertisement
3
Faults and what to do
about them.
Emergency release
F a u l t s a n d w h a t t o d o a b o u t t h e m .
E.g. in the event of a power cut
The programme continues when the
power supply is restored.
However, if the laundry has to be
removed, the washing machine door
can be opened as follows:
:
Warning
Risk of scalding!
When you are washing at high
temperatures, there is a risk of scalding
if you come into contact with hot
detergent solution and laundry.
If possible, leave it to cool down first.
:
Warning
Risk of injury!
Reaching into the drum while it is still
turning may cause hand injuries.
Do not reach into the drum when it is
turning.
Wait until the drum has stopped turning.
Information on the display panel
Display
E3
E5
E6
E2
@
Other displays
Cause/remedy
Close the washing machine door properly; washing may be trapped.
■
Turn the tap on fully. ~ Page 29
■
Supply hose kinked/jammed.
■
The water pressure is too low. Clean the filter. ~ Page 22
■
Detergent solution pump blocked. Clean the drain pump. ~ Page 21
■
The drain hose/drain pipe is blocked. Clean the drain hose at the siphon.
■
~ Page 22
Motor fault. Call the after-sales service.~ Page 25
■
Childproof lock is active; deactivate it.~ Page 18
■
Switch off the appliance, wait for five seconds and then switch it on again. If the
■
display appears again, call the after-sales service. ~ Page 25
Faults and what to do about them.
Caution!
Water damage
Any escaping water may cause water
damage.
Do not open the washing machine door
if water can be seen through the glass.
Switch off the appliance. Pull out the
1.
mains plug.
Drain the detergent solution
2.
Use a tool to pull the emergency
3.
release downwards and then
release.
The washing machine door can then
be opened.
en
23
Advertisement
Table of Contents
