Hose And Cable Lengths; Water Connection; Water Inlet - Bosch WAE28262GB Instruction Manual And Installation Instructions

Hose and cable lengths

Left-hand connection
Right-hand connection
Tip:
The following are available from
specialist retailers/our after-sales
service:
Extension for the AquaStop and cold
■
water supply hose (approx. 2.50 m).
Order no. WMZ2380, WZ10130,
Z7070X0
A longer supply hose (approx. 2.20
■
m) for standard models. Individual
component number for the after-
sales service: 00353925

Water connection

:
Warning
Risk of death!
There is a risk of electric shock if live
components are touched.
Positioning and connecting
Do not immerse the AquaStop safety
valve in water (it contains an electric
valve).
Caution!
Water damage
The connection points for the water
supply hose and water drain hose are
under high water pressure. To prevent
leaks and water damage, you must
follow the instructions in this section.
Observe the following when connecting
the machine:
Notes
In addition to the information listed
■
here, the local water and electricity
supplier may have special
requirements.
Only operate the washing machine
■
using cold mains water.
Do not connect the washing
■
machine to the mixer tap of an
unpressurised hot-water boiler.
Do not use a used supply hose. Only
■
use the supply hose supplied or one
that was purchased from an
authorised specialist retailer.
If in doubt, have the appliance
■
connected by a technician.

Water inlet

Notes
Do not bend, squash, modify or cut
■
through the water supply hose
(otherwise its strength is no longer
guaranteed).
Only tighten the screw connection by
■
hand. If the screw connections are
tightened too much with a tool
(pliers), the thread may be
damaged.
Optimum water pressure in the supply
network
At least 100 kPa (1 bar)
Maximum 1000 kPa (10 bar)
en
29