NEC NEAX 2400 IPX Programming Manual page 41

IRL (CDN15)
0 = –
1 = Clear call when DTI alarm is detected
Note 2: This data should be set when there is no Dch in the physical DTI.
MTC (CDN16)
0-15 = TC (CDN18) × MTC (Restart timer value)
TC (CDN17)
0 = –4
1 = 64 msec.5
2 = – 6
3 = 2 sec.7
DVRST (CDN20) Call restriction while Tie Line is backed up on ISDN.
0 = No Restriction
1 = Speech call restriction (Speech. 3.1 kHz audio, 7 kHz audio calls are restricted.)
2 = Data call restriction (Unrestricted digital, restricted digital and Video data are
restricted.)
3 = Both Speech and Data calls are restricted.
RSCT (CDN21)
0 = No Restriction
1 = Restriction
This data is effective when TMPRT = 1.
Note 3:
ROCG (CDN22)
0 = –
1 = Effective
This data is effective when TMPRT = 1.
Note 4:
RICG (CDN23)
0/1 = Out of Service/In Service
Note 5: This data is effective when TMPRT = 1.
STSENQ (CDN24) Status Inquiry Message Send
0/1 = Out of Service/In Service
This data is not effective in Australia.
Note 6:
RETMSG (CDN30) Return Message for Connect ISDN LINE with Analog Trunk
0 = CALL PROC. + ALERT
1 = CALL PROC. + ALERT or CALL PROC. + PROGRESS
Clear call when DTI alarm is detected.
Assignment of Timer T309 Value. Restoration timer (TC×MTC) sec.
Timer T309 Counter Value
= 30sec.
= 5 min.
= 1 sec.
= –
Call restriction by Temporary Route Information
Outgoing Call Account by Temporary Route Information
Incoming Call Account by Temporary Route Information
NDA-24305
COMMANDS CONCERNING ISDN DATA ASSIGNMENT
Note 2
Note 3
Note 6
Note 4
Note 5
CHAPTER 4
Page 23
Revision 1.0