Synchronous Data Switching-Pri - NEC NEAX 2400 IPX Programming Manual

S-87

SYNCHRONOUS DATA SWITCHING-PRI

1. General Description
A synchronous DTE connected to a D
connected to a Synchronous D
2. Operating Procedure
To originate a data call from the sync./async. D
1. Press the "DATA" key on the D
2. Use the keypad to dial the desired DTE extension.
refers to the called extension number).
3. The DATA LED will flash an
4. When the called DTE answers, the display is changed as follows,
RDY D DTE XXXX
(Time Display)
5. A transparent data path is established, and data communication can begin.
To terminate the data call, either user may press the "DATA" key. The other party's LCD will display as shown
below for five seconds.
RLS D DTE XXXX
(Time Display)
Both parties' DATA and DTX LEDs will be extinguished.
3. Programming
See [S-86] "SIMULTANEOUS VOICE AND DATA
term
/Data Adapter can communicate via the PBX with a synchronous DTE
term
/Data Adapter.
term
term
. The LED above the key will illuminate and "D" will appear on the LCD.
D DTE XXXX
(Time Display)
term
for D Series III or
term
(D Series III) or
RELEASE D DTE XXXX
NDA-24305
SYNCHRONOUS DATA SWITCHING-PRI
/Data Adapter:
will appear on the display ("XXXX"
D XXXX
(Time Display)
d ,will appear (flashing) on the LCD.
READY D DTE XXXX
(Time Display)
(Time Display)
TRANSMISSION-PRI".
term
for D Series E.
term
(D Series E).
CHAPTER 5
Revision 1.0
Page 147