Operation; Holding The Tool - Makita 6953 Instruction Manual

2. For socket with O-ring and pin
1
2
► 1. Socket 2. O-ring 3. Pin
Move the O-ring out of the groove in the socket
and remove the pin from the socket. Fit the socket
onto the anvil of the tool so that the hole in the
socket is aligned with the hole in the anvil. Insert
the pin through the hole in the socket and anvil.
Then return the O-ring to the original position in
the socket groove to retain the pin. To remove
the socket, follow the installation procedures in
reverse.
Installing and removing hook
1
► 1. Hook 2. Expand
The hook is convenient for temporarily hanging the tool.
This can be removed without using a tool. This can be
installed on either side of the tool.
Expand the upper part of the hook in both directions
and remove it. To install the hook, follow the removal
procedure in reverse.

OPERATION

Holding the tool

3
1
► 1. Metal part 2. Handle
Hold the tool only by the handle when performing an
operation. Do not touch the metal part.
The proper fastening torque may differ depending upon
the kind or size of the bolt, the material of the workpiece
to be fastened, etc. The relation between fastening
torque and fastening time is shown in the figures.
Standard bolt
2
5 ENGLISH
2
.
N m
.
(kg cm)
140
(1,428)
120
(1,224)
100
M14
(1,020)
80
M12
(816)
60
(612)
40
(408)
20
(204)
0
1
Fastening time
M16
M16
M14
M12
Seconds
2 3