Connect Cables - Cisco DX-80 User Manual

DX 80 Connection

Connect Cables

1. Place the DX80 face down on a flat surface to connect the cables. Do not exert force on the camera as this may damage it.
2. Flip the connector cover up to access the connector panel and lead the cables under the strain relief bar.
3. Connect the Ethernet cable (A) between the network connector 1 and a network wall socket.
4. Connect the provided power adapter and cable (B) between the DX80 2 and a power socket.
5. Pull the foot stand, set the DX80 in an upright position and adjust the angle. The foot stand is stiff to open at first.
To use the same network wall socket for both your computer and DX80, connect your computer to the computer network port
on the DX80, and the DX80 to the network wall socket (see step 3).
Prepared by Information Technology