Checking The Network Status And Settings - Canon imageCLASS LBP122dw User Manual

Checking the Network Status and Settings

You can perform a connection test with devices in the network to check whether the machine is correctly connected to
the network.
The IP address of the machine and the MAC address information are needed to use Remote UI and configure the
firewall settings. Check these current settings.
Checking Whether the Machine Can Connect to Network Devices(P. 66)
Viewing the IP address set to the machine(P. 67)
Viewing the MAC Address of the Wired LAN(P. 67)
Viewing the MAC Address and Connection Information of the Wireless LAN(P. 68)
● If the IP address is displayed as "0.0.0.0," it is not correctly configured. Set the IP address again.
Setting IPv4 Addresses(P. 50)
Setting IPv6 Addresses(P. 52)
● Connecting the machine to a switching hub, for example, may prevent connection to the network even when
the IP address is correctly configured. In this case, set a wait time until machine starts communicating and
try connecting again.
● You can print the System Manager Data List to view the network settings.
and Lists(P. 186)
Checking Whether the Machine Can Connect to Network Devices
In the Web browser of the computer connected to the network, enter the IPv4 or IPv6 address of the machine. If the
Remote UI login screen is displayed, the machine is properly connected to the network.
When using an IPv4 address, you can use the following procedure to send a ping command from the operation panel
to check whether the machine can connect to a network device.
Required Preparations
● Prepare the IPv4 address of a device in the network to which you want to connect and keep it close by.
1
On the operation panel, select [Menu] in the [Home] screen, and press
Screen(P. 81)
2
Press [Preferences]
Settings]
If the login screen appears, enter the System Manager ID and PIN, and then press
ID and PIN(P. 4)
3
Enter the IPv4 address of a network device, and press
➠
If the machine is correctly connected to the network, [Received response from host.] appears.
Setting Up
[Waiting Time for Connection at Startup](P. 205)
[Network]
[PING Command]
[TCP/IP Settings]
.
.
66
Printing and Viewing Reports
Starting Remote UI(P. 179)
. [Home]
[IPv4
. System Manager
94RC-01W