Table of Contents
Advertisement
using your mixer on the stand
Before first use
Make sure your mixer is switched off and unplugged from the mains supply
socket before cleaning, detaching or fitting it to the mixer stand or before fitting or
removing the beaters, dough hooks or whisk.
Before using your mixer for the first time, wash the beaters, dough hooks, whisk and
stainless steel bowl in warm, soapy water. Rinse and dry thoroughly. Do not use harsh
abrasives, chemicals or oven cleaners. Using a damp cloth or sponge, wipe the exterior
of the hand mixer and mixer stand. Dry thoroughly.
Using on the stand
Always avoid contact with moving parts while the appliance is in operation. Keep
hands, hair, clothing as well as other utensils away from the beaters, dough hooks
or whisk during operation.
Never attempt to remove or replace the beaters, dough hooks or whisk whilst your
food mixer is in operation, or plugged in to the mains supply.
1.
Ensure that your mixer is unplugged from the supply socket and the speed selector
is set to 0 (off).
2.
Insert beaters one at a time, by placing the stem end of beaters into the opening
drive holes on the bottom of the mixer. Turn beater slightly and push in until beater
clicks into position. (see Figure A)
NOTE: the beaters and dough hooks are not interchangeable. The beater and
dough hook with the gear on the stem fits into the large drive hole on the mixer. The
whisk should be placed into the small drive hole on the right. If the beaters, dough
hooks and whisk do not click into the drive holes, reverse and try again.
3.
Hold the geared bowl locking plate on the mixer stand, position the mixing bowl over
the mixer stand (see figure B) and rotate the mixing bowl in a clockwise direction
until it clicks into position.
4.
Connect the hand mixer to the mixer stand by sliding in the hand mixer into the 4
prongs on the stand and until it clicks into place (see Figure C). Ensure that the
hand mixer and mixer stand are firmly connected together.
5.
Add the ingredients to the mixing bowl.
6.
Plug your mixer into the mains supply socket.
7.
Turn the on/off speed selector switch to 1 to start mixing. Adjust the speed as
required (see Mixing speeds on page 10).
8.
Slide the SwivelScrape™ technology control switch to the left to manoeuvre the
beaters to scrape the bowl while mixing for uniform consistency (see Figure D).
Move the hand mixer side to side as needed to reach all areas of the bowl. When
completed, move the hand mixer back to the original position and lock in place.
Note: When kneading bread dough for best results, it is recommended that the
mixer head is kept in the fixed position.
9.
For best results, use the whisk attachment with the mixer off the stand.
6
VFM029_22EM2 (UK).indd 6-7
VFM029_22EM2 (UK).indd 6-7
using your mixer on the stand
Figure A
Figure C
Figure B
Figure D
7
2022/3/18 9:03 AM
2022/3/18 9:03 AM
Advertisement
Table of Contents
