Initializing Settings (Default Recall) - Sony MLS-X1 User Manual

The parameters return to the initial status saved data
setting values.
Entering parameters using the utility
control block
Press the [MENU] button in the utility control block to
switch to menu parameter operation mode.
You can set parameters of the currently displayed menu
using the adjustment knobs.
Adjustment knobs 1 to 5 correspond to the parameter 1 to
5 buttons. Adjust parameters by turning the adjustment
knobs clockwise or counterclockwise.
Note
The control panel must be linked with the menu.
For details, see "Linking a Control Panel with the Menu"
(page 78).
Setting parameters using the device
control block
Press the [MENU] button in the device control block to
switch to menu parameter operation mode.
You can set parameters of the currently displayed menu
using the trackball and Z-ring.
• The trackball X-axis direction corresponds to the
parameter 1 button. Adjust the parameter by moving the
trackball left/right.
• The trackball Y-axis direction corresponds to the
parameter 2 button. Adjust the parameter by moving the
trackball up/down.
• The Z-ring corresponds to the parameter 3 button.
Adjust the parameter by turning the Z-ring clockwise or
counterclockwise.
• Press the [FINE] button to switch to fine mode,
enabling fine adjustment of setting values using the
trackball and Z-ring.
Note
The control panel must be linked with the menu.
For details, see "Linking a Control Panel with the Menu"
(page 78).

Initializing Settings (Default Recall)

You can return a menu to the initial status saved data
setting value if a default recall button is displayed.
Notes
• You can initialize a parameter setting values using a
default recall button in the analog controls window.
For details, see "Returning parameters to the initial
settings" (page 75).
• You can initialize a key setting values using buttons in
the key control block.
For details, see "Initializing Key Settings" (page 137).
• You can initialize switcher bank and two-dimensional
transform (resizer) setting values using buttons in the
device control block.
For details, see "Reducing, enlarging, moving, and
rotating keys (device control block)" (page 138).
• You can initialize three-dimensional transform (DME)
setting values using buttons in the device control block
or the menu.
For details, see "Three-Dimensional Transform
Operations (Device Control Block)" (page 199) and
"Three-Dimensional Transform Operations (Menu)"
(page 202).
Default recall button
1
Press the [Default Recall] button.
2
Check the message, then press [OK].
The menus below the selected level 3 menu return to
their initial settings.
Note
In the case where a level 3 menu does not exist, the
menus below the level 2 menu return to their initial
settings.
Default recall target menus
• Home > M/E-x > Keyx menus
• Home > M/E-x Sub > Keyx menus
• Home > P/P > Keyx menus
• Home > P/P Sub > Keyx menus
(M/E-x = M/E-1 to M/E-5, Keyx = Key1 to Key8)
When default recall is executed, all the menus below the
level 3 menu return to their initial settings.
However, the settings in the following lower level menus
are not affected by default recall.
• Type > Type Select menu > [Video Process] button
settings
76