Setting A Crop - Sony MLS-X1 User Manual

No. Parameter
4 Bottom
5 All
When the [Beveled Color Edge] button is selected,
select the target edge (Top, Left, Right, Bottom, All)
to adjust in the [Color Adjust] group and set the
following parameters.
No. Parameter
1 Luminance
2 Saturation
3 Hue
To soften the border
Set the [Border Soft] button to the on state.
When the [Flat Color] button is selected, set the following
parameters.
No. Parameter Adjustment
1 Inner Soft Softness of inner edge of border
When the [Beveled Light Edge] button or [Beveled Color
Edge] button is selected, set the following parameters.
No. Parameter Adjustment
1 Inner Soft Softness of inner edge of border
2 Bound Soft Softness of border boundary
Setting a border (device control block)
When the border setting is enabled in the menu, you can
adjust the border width of the top, bottom, left, and right
edges using the device control block.
Note
The buttons used for configuring a border must be
assigned to the device control block beforehand.
For details about assigning buttons, see "Assigning
Control Panel Buttons" (page 402).
1
Press the [M/E 1] button.
2
Press the [K1RSZ] button.
3
Press the [RSZR ON] button, turning it on.
4
Press the [BDR/CROP] button, turning it on amber.
5
Adjust the border width using the trackball or Z-ring.
Trackball (horizontal rotation): Adjusts the border
width in the X-axis direction (left/right edges)
Adjustment
Position of bottom edge
Simultaneous adjustment of
position of top, bottom, left,
and right edges
Adjustment
Luminance
Saturation
Hue
Trackball (vertical rotation): Adjusts the border
width in the Y-axis direction (top/bottom edges)
Z-ring: Adjusts the border width simultaneously in
the X-axis and Y-axis directions
To finely adjust the setting values of parameters
Press the [FINE] button, turning it on.
The adjustment mode switches to fine mode, enabling
fine adjustment of setting values using the trackball/
Z-ring.
To restrict the parameters targeted by the
operation
Press the [X] button, [Y] button, or [Z] button,
turning it on.
This enables operation only for the selected axis
using the trackball/Z-ring.

Setting a Crop

Note
When a video signal and key signal are selected for
resizer mosaic/defocus, crop is disabled.
Setting a crop (menu)
1
Open the Home > M/E-1 > Key1 > Resizer/Proc Key
> Resizer Adjust/DME Select menu (11101.41).
2
Set the [Resizer] button to the on state.
3
Set the [Crop] button to the on state and set the
following parameters.
No. Parameter
1-1 H
1-2 V
1-3 All
2-1 Top
2-2 Left
2-3 Right
2-4 Bottom
a) The entered numeric value is automatically a positive value for the
right and top edges and a negative value for the left and bottom
edges.
To soften the edges
Set the [Edge Soft] button to the on state and set the
following parameter.
141
Adjustment
Simultaneous adjustment of
crop of left and right edges
Simultaneous adjustment of
crop of top and bottom edges
Simultaneous adjustment of
crop of top, bottom, left, and
a)
right edges
Crop of top edge
Crop of left edge
Crop of right edge
Crop of bottom edge
a)
a)