Existing Text; Superscript And Subscript - Brady M710 User Manual

Existing Text

To apply an attribute to previously entered text:
1. Select the text to which you want to apply the
attribute.
•
•
Note: Highlighting works on a line-by-line basis. You cannot highlight more than one line at a time.
2. Press FONT.
3. Select the attribute, then select On (bold, italics, and underline) or the percentage of expanded
or condensed text.
All highlighted text displays the attribute.
To remove the highlighting from the characters, press any navigation key or touch anywhere
on the screen.
To remove an attribute that was previously applied to some text:
Repeat the steps for applying the attribute but select Off instead.

Superscript and Subscript

Superscript places a character slightly above the line of type and subscript places a character slightly
below the line of type. The super- or subscript character also displays slightly smaller than the normal
line of type. Super- and subscript functions are on the numeric keypad. Pressing either key applies that
format to the next character typed. It immediately turns off after the character is entered and you are
returned to the normal line of type.
To apply superscript or subscript to a single character:
1. Position the cursor in the line of text where the superscript or subscript character will display.
2. Press FN + SUPER (on the 8 key) for superscript or FN + SUB (on the 0 key) for subscript.
3. Type the character to be displayed in superscript or subscript.
Only the character typed directly after pressing the superscript or subscript key is displayed in super-
or subscript.
To apply superscript or subscript to multiple characters:
1. Type the characters that you want to put into super- or subscript.
2. Position the cursor at the beginning of the character string that you want to display in super- or
subscript.
M710 User Manual
Using the keyboard: Hold SHIFT while
moving the cursor with the navigation keys
across the characters to which the attribute will
be applied.
Using the touchscreen: At the beginning of
the character string that will display the
attribute, touch and briefly hold on the screen
until the cursor disappears.
Highlight the data by dragging your finger across the screen to the end of the character
string that will display the attribute.
Editing Labels on the Printer
Formatting Text
42