Setting When Bknw-116 Is Connected - Sony Betacam SX DNW-A100 Maintenance Manual

1-15. Settings and Adjustment when Peripheral Equipment is Connected

1-15-5. Setting when BKNW-116 is Connected

Refer to "1-7. How to Connect Hybrid Recorder" of BKNW-116 installation manual for connecting this
unit to BKNW-116.
[|Importance|] [|Importance|] [|Importance|]
[|Importance|] [|Importance|]
Check the ROM version (SY1, SY2, SSX and SV) of the unit by C40: ROM VERSION of the mainte-
nance mode before connecting to BKNW-116.
SY1A: ROM version 3.10 or higher
SY1B: ROM version 3.10 or higher
SY2: ROM version 3.01 or higher
SSX: ROM version 3.10 or higher
SV: ROM version 3.01 or higher
If the ROM version is lower than the value described above, the version-up must be required. For the
version-up, contact your local Sony Sales Office/Service Center.
BLACK file installation
When BKNW-116 is first used after factory-shipping, maintenance menu D4 : BLACK INSTALLATION
is automatically started when the power is first turned on after connection to this unit.
Be sure to install the BLACK file using this menu.
(Refer to "4-3-6. BLACK File Installation Menu (D4)".)
Selection of Hard Disk Drive Zone
After connecting, it is required to change the zone of HDD so as to be available HDDs in the BKNW-116.
The zone is changed by the maintenance menu of this unit. Refer to "4-3-7. Zone Configuration Menu
(D5)" for changing the zone.
1-30
DNW-A100/A50/A45
DNW-A100P/A50P/A45P