Signal Inputs And Outputs - Sony Betacam SX DNW-A100 Maintenance Manual

1-8. Signal Inputs and Outputs

1-8. Signal Inputs and Outputs
Remote connector
7 SCSI
7 REMOTE (9P)
7 RS-232C
7 VIDEO CONTROL
Input connector
1 DIGITAL INPUT, SDTI
(for DNW-A100/A100P only)
2 DIGITAL INPUT, SDI
3 AUDIO INPUT (Standard)
AUDIO INPUT (AES/EBU)
(with optional kit BKNW-105)
4 TIME CODE IN
6 VIDEO INPUT, REF.VIDEO
6 VIDEO INPUT, COMPOSITE
(Usable with optional board BKDW-505/506)
6 VIDEO INPUT, COMPONENT
(Usable with optional board BKNW-104)
1-10
< Reduced drawing of rear panel >
1 2
4
3
5
7
68P connector
Differential type bus (SCSI-2)
D-SUB 9P connector (RS-422A interface)
Remote control
D-SUB 25P connector (RS-232C interface)
for ISR (Interactive Status Reporting)
D-SUB 15P connector
for a TBC remote controller (BVR-50) connection
BNC x 1 (Optional kit BKNW-103)
Serial data transport interface (270 Mbit/s), complies with SMPTE 305M
BNC x 1 (active through out x 1)
Serial digital interface (270 Mbit/s), complies with SMPTE 259M & ITU-R BT.656
XLR3-pin x 4 (1 set : CH1, CH2, CH3, and CH4)
Analog audio 4 channels
LOW OFF : _60 dBu, high impedance, balanced
HIGH OFF : +4 dBu (Standard), high impedance, balanced
HIGH ON : +4 dBm (Standard), 600 Z termination, balanced
BNC x 2 (1 set : CH1/2 and CH3/4)
Digital audio 4 channels
AES/EBU format, complies with AES-3id-1995
XLR3-pin x 1
Time code 0.5 to 18 V p-p, 10 kZ, balanced
BNC x 2 in loop through connection
Outside reference video signal (Black burst or composite sync)
0.3 V p-p, 75 Z, sync negative
BNC x 2 in loop through connection
Analog composite video 1.0 V p-p, 75 Z, sync negative
BNC x 3 (1 set : Y, R-Y, and B-Y)
Analog component video
Y
R-Y/B-Y : 0.7 V p-p, 75 Z
6
: 1.0 V p-p, 75 Z, sync negative
AC IN
BREAKER
DNW-A100/A50/A45
DNW-A100P/A50P/A45P