Error Messages; Alarm Display; Alarm Display When The Main Power Is Turned On - Sony DSR-DR1000 Service Manual

3-1. Alarm Display

This unit has an alarm display function.
When a problem is detected, an alarm is displayed immediately in the timer counter block. The alarm and a message
describing the countermeasure are displayed on a video monitor connected to the SUPER connector.
This unit has two types of alarms : one is for operators while the other is for service persons. This manual describes only
the alarms for service persons. For details of alarms for operators, refer to the operating instructions. Activating the alarm
display may influence the system, such as when the reference video signal is not used. Therefore, you can select whether
or not to display the alarm from the Setup menu selection. As for Setup menu, refer to the operating instructions. Howev-
er, the alarms for service persons are displayed regardless of the Setup menu setting.

3-1-1. Alarm Display when the Main Power is Turned On

Detection :
Operation after detection : None
Display :
Detection :
Operation after detection : The Setup menu operates
Display :
DSR-DR1000/DR1000P
Section 3

Error Messages

Checks the settings of switch
S1601-1 to 2 on the DPR-224
board and the contents of non-
volatile memory (EEPROM).
The alarm is displayed until
any key is pressed.
Checks the version of the
Setup menu.
using the factory settings. The
contents of the non-volatile
memory (EEPROM) remain
unchanged. Therefore, if the
setting of the Setup menu is
not changed, the same alarm
will appear when the main
power is turned on.
The alarm is displayed until
any key is pressed.
ALARM
SETT I NG HAS BEEN
CHANGED TO
DSR-DR1000 NTSC(UC)
CHECK THE S1601-1~2
SW I TCH ON THE DPR BOARD.
This example of the display is for
DSR-DR1000 (UC).
ALARM
THE SETUP MENU SOFTWARE
HAS BEEN UPGRADED.
SET THE SETUP MENU I TEMS
TO THE DES I RED SETT I NGS
OR ACT I VATE THE ' LOAD
MENU DATA ' (MA I NTENANCE
MENU) FUNCT I ON.
3-1 (E)