Advertisement
Installing or removing di.ill bit
CAUTION :
Always be sure that the tool is switched off and unplugged before installing or removing
the bit.
To install the bit, place it in the chuck as
far as it will go. Tighten the chuck by hand.
Place the chuck key in each of the three
holes and tighten clockwise.
Be sure to
tighten all three chuck holes evenly.
To remove the bit, turn the chuck key
counterclockwise in just one hole, then
loosen the chuck by hand.
Adjusting depth of drilling
Loosen the screw and adjust the depth
gauge to the desired depth. After adjusting,
tight:en the screw.
Speed change
To change the tool speed, press the change
lever and slide it to the ``LO" position for
low speed or the ''Hl" position for high
speed.
If the change lever does not slide
easily,
turn the chuck
slightly
in either
direction while sliding the change lever.
Advertisement
