Removing The Left Control Panel - Dell PowerEdge R760 Installation And Service Manual

Figure 254. Installing the right control panel
Next steps
1. Install the side wall bracket.
2. Install the cooling fan cage
3. Install the drive backplane
4. If removed, install the air shroud
5. Follow the procedure listed in

Removing the left control panel

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the drive backplane
4. If installed, remove the air shroud
5. Remove the cooling fan cage
6. Remove the side wall
Steps
1. Using the Phillips #1 screwdriver, remove the screws that secure the left control panel and the cable cover to the system.
2. Remove the cable cover away from the system.
3. Disconnect the control panel cable from the connector on the system board.
4. Holding the cable, slide the left control panel out of the system.
NOTE: Observe the routing of the cable as you remove the left control panel from the system.
assembly.
cover.
or install the GPU air shroud
After working inside your
Safety
Before working inside your
cover.
or remove the GPU air
assembly.
bracket.
system.
instructions.
system.
shroud.
Installing and removing system components 303