Intrusion Switch; Removing The Intrusion Switch Module; Installing The Intrusion Switch Module - Dell PowerEdge R760 Installation And Service Manual

Intrusion switch

This is a service technician replaceable part only.

Removing the intrusion switch module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the expansion card
NOTE: Ensure that you note the routing of the cable as you remove it from the system board. Route the cable properly
when you replace it to prevent the cable from being pinched or crimped.
Steps
1. Disconnect the intrusion switch cable from the connector on the rear I/O board.
2. Using a Phillips #1 screwdriver, loosen the screw on the intrusion switch module.
3. Slide the intrusion switch module out of the slot on the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 234. Removing the intrusion switch module
Next steps
1. Replace the intrusion switch

Installing the intrusion switch module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
284 Installing and removing system components
Safety instructions.
Before working inside your
riser.
module.
Safety instructions.
Before working inside your
system.
system.