Removing The Drive From The Drive Carrier - Dell PowerEdge R760 Installation And Service Manual

1. Follow the safety guidelines listed in
2. Remove the front bezel.
3. Remove the drive carrier or remove the drive blank when you want to assemble the drives into the system.
Steps
1. Slide the drive carrier into the drive slot and push until the drive connects with the backplane.
2. Close the drive carrier release handle to lock the drive in place.
Figure 59. Installing a drive carrier
Next steps
install the front bezel.

Removing the drive from the drive carrier

Prerequisites
1. Follow the safety guidelines listed in the
2. Remove the drive carrier.
Steps
1. Using a Phillips #1 screwdriver, remove the screws from the slide rails on the drive carrier.
NOTE: If the drive carrier has Torx screw, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive) screwdriver to
remove the drive.
2. Lift the drive out of the drive carrier.
Safety instructions.
Safety instructions.
Installing and removing system components 109