Black & Decker BEPW1300L Original Instructions Manual page 9

@
Assembly and Adjustments
WARNING: Before attempting any of the following
operations, make sure that the tool is switched off
and unplugged.
Attaching Spray Handle (Fig. A)
1. To connect the spray handle ( 4 ) to the spray wand ( 2 ),
insert the end of the spray handle onto the end of the
spray wand.
2. Press in and turn the spray handle counterclockwise to
lock it into position.
Attaching High Pressure Hose (Fig. B)
NOTICE: Never pull high pressure hose or water
supply hose to move pressure washer. This could
damage hose and/or pump inlet and/or pump outlet.
1. To connect the high pressure hose ( 1 ) to the
spray handle ( 4 ), depress the hose connect button ( 13 )
while clicking the hose end ( 23 ) into the spray handle.
Release the hose connect button when the hose end has
clicked into position.
2. To connect the high pressure hose to the pressure washer
unit ( 16 ), screw the hose collar ( 24 ) onto the high
pressure water outlet ( 20 ).
NOTE: Uncoil the high pressure hose before installation to
prevent kinks.
NOTE: Avoid cross threading when installing the hose.
Cross threading will cause leaks.
Attaching Garden Hose (Fig. C‑J2)
NOTE: Before connecting the garden hose to the pressure
washer unit, run water through the garden hose for thirty
seconds to clear any debris from inside the garden hose.
1. To connect the garden hose to the pressure washer
unit ( 16 ), screw the filter ( 10 ) to the water intake ( 25 ).
2. Connect the garden hose to the hose connector ( 9 ) by
loosening the screw of the garden connector and attaching
the hose onto the connector. Connect the garden hose to
the hose connector ( 9 ) by screwing the garden hose to
the garden connector.
3. Attach the garden hose ( 28 ) mounted onto the garden
connector to the filter ( 10 ) until it "clicks".
NOTE: Always disconnect the garden hose after usage.
@
Attaching Nozzles (Fig. D)
DANGER: Risk of fluid injection. Do not direct
discharge stream toward persons, unprotected skin,
@
eyes or any pets or animals. Serious injury will occur.
WARNING: Flying objects could cause risk of serious
injury. DO NOT attempt to change nozzles while
pressure washer is running. Turn pressure washer
unit OFF before changing nozzles.
(Original instructions)
1. To connect a nozzle to the spray wand ( 2 ) , depress
the nozzle button ( 3 ) on the spray wand and insert the
appropriate nozzle.
2. Release the button to lock the nozzle in place.
3. Give the nozzle a firm tug to ensure the nozzle is locked
into place.
Spray Fan to Pencil Jet Nozzle
Adjusting Fan Pattern (Fig. D1, D2)
The angle of spray coming out of the spray wand may be
adjusted by rotating the nozzle. This will vary the spray pattern
from approximately a 0 ° narrow high impact stream to a 60 °
wide fan spray.
A wide fan pattern distributes the impact of the water over
a larger area, resulting in excellent cleaning action with a
reduced risk of surface damage. Large surface areas can be
cleaned more quickly using a wide fan pattern.
A narrow pencil jet stream distributes the impact of the water
in a concentrated area, resulting in a high impact force on
the cleaning surface. Use a narrow pencil jet stream for deep
cleaning in a concentrated area. However, use it cautiously, as
it may damage some surfaces.
Attaching Soap Bottle (Fig. I4)
To connect the soap bottle ( 11 to the spray handle ( 4 , insert
the end of the soap bottle inside the spray handle and turn the
soap bottle counterclockwise to lock it into position.
NOTE: The wand and soap bottle cannot be installed at the
same time.
NOTE: The soap bottle should be positioned underneath the
barrel of the spray handle. Do not position the soap bottle
above the barrel of the plastic gun as this will lead to soap
dripping on the barrel.
Spray fan to pencil jet
nozzle
Turbo Nozzle
@
Operation
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from power
source before making any adjustments or removing/
installing attachments or accessories. An accidental
start‑up can cause injury.
@
Proper Hand Position (Fig. E)
WARNING: To reduce the risk of serious personal
injury, ALWAYS use proper hand position as shown.
ENGLISH
For gentle wide
area cleaning.
For abrasive cleaning.
(Included with BEPW2000
model only)
9