Table of Contents
Advertisement
SECTION 4: OPERATIONS
Operation Overview
The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual, seek additional training from experienced
machine operators, and do additional research
outside of this manual by reading "how-to" books,
trade magazines, or websites.
To reduce your risk of
serious injury, read this
entire
using machine.
To reduce risk of eye injury from flying
chips or lung damage from breathing dust,
always wear safety glasses and a respirator
when operating this machine.
Never mortise treated lumber—the smoke is
extremely poisonous.
-20-
manual
BEFORE
To complete a typical operation, the operator
does the following:
1.
Puts on safety glasses and respirator.
2.
Installs chisel and auger in chuck.
3.
Places workpiece on table flush with fence.
4.
Adjusts fence to correct position for operation.
5.
Secures workpiece in place with the hold-
down.
6.
Adjusts depth stop for desired mortise depth.
7.
When all safety precautions have been taken,
turns machine ON.
8.
Using hand lever, slowly feeds chisel and
auger into workpiece until correct depth is
reached.
9.
Raises hand lever to extract chisel and auger
from workpiece.
10. Turns machine OFF.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
Model T33127 (Mfd. Since 10/21)
Advertisement
Table of Contents
