Section 4: Operations; Operation Overview - Grizzly G0781 Owner's Manual

SECTION 4: OPERATIONS

Operation Overview

The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual, seek additional training from experienced
machine operators, and do additional research
outside of this manual by reading "how-to" books,
trade magazines, or websites.
To reduce your risk of
serious injury, read this
entire
using machine.
To reduce risk of eye or face injury from
flying chips, always wear approved safety
glasses and face shield when operating this
machine.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
-20-
manual BEFORE
To reduce risk of injury from unexpected
startup of spindle at high speeds, always
rotate variable-speed dial to the "0" setting
before starting spindle.
To complete typical operation, operator does
the following:
1.
Examines workpiece to make sure it is suit-
able for cutting/drilling.
2.
Securely clamps workpiece to table.
3.
With machine disconnected from power,
installs correct tooling.
4.
Adjusts headstock height above table.
5.
Rotates variable-speed dial to "0" set-
ting, selects spindle direction, and resets
Emergency Stop button.
6.
Uses speed range lever to select proper
spindle speed range.
7.
Puts on required safety glasses and face
shield.
8. Connects machine to power, presses ON
button, and rotates variable-speed dial to cor-
rect spindle speed.
9. Uses downfeed controls or table controls to
perform operation.
10. Presses Emergency Stop button and waits
for spindle to completely stop before remov-
ing workpiece, changing tooling, or changing
spindle speeds.
11. Disconnects machine from power.
Model G0781 (Mfd. Since 2/15)