Table of Contents
Advertisement
SECTION 4: OPERATIONS
Operation Overview
The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual, seek additional training from experienced
machine operators, and do additional research
outside of this manual by reading "how-to" books,
trade magazines, or websites.
To reduce your risk of
serious injury, read this
entire
using machine.
Eye injuries, respiratory problems, or hear-
ing loss can occur while operating this
tool. Wear personal protective equipment to
reduce your risk from these hazards.
Keep hair, clothing, and
jewelry away from mov-
ing parts at all times.
Entanglement can result
in death, amputation, or
severe crushing injuries!
-24-
manual
BEFORE
To complete a typical operation, the operator
does the following:
1.
Examines workpiece to make sure it is suit-
able for milling/drilling.
2.
Securely clamps workpiece to table.
3.
With machine disconnected from power,
installs correct tooling.
4.
Rotates spindle speed dial all the way
counterclockwise.
5.
Puts on personal protective equipment.
6.
Sets FWD/REV switch to suit cutting opera-
tion/tooling, connects machine to power, and
resets E-STOP button.
7.
Rotates spindle speed dial clockwise to turn
spindle rotation ON, and sets correct spindle
speed for operation.
8.
Adjusts headstock height above table.
9.
Uses table, headstock, or downfeed controls
to perform operation.
10. Turns spindle rotation OFF when complete.
11. Waits for spindle to completely stop before
removing workpiece or changing spindle
direction.
12. Disconnects machine from power before
changing/removing tooling.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
Model G0935 (Mfd. Since 04/21)
Advertisement
Table of Contents
