Setting Up Your Router For Internet Access - NETGEAR RangeMax WNR1000 Install Manual

Table 2. Status Lights After Installation (continued)
Label
5. LAN
(Ports 1–4)

Setting Up Your Router for Internet Access

When configuring your wireless router manually, you must log in to your wireless router to set it
up initially and to make any changes to your wireless router's settings later.
You can use the wireless router Restore Factory Settings button to return the
wireless router to its default state. See
Configuration Settings" on page 39
To access the router:
Type http://www.routerlogin.net in the address field of your browser, and then click Enter.
1.
You can enter either of these addresses to connect to your wireless router:
http://www.routerlogin.net or http://www.routerlogin.com.
A login window similar to the one shown in
Figure 12
18
Description
A LAN light should be lit for each connected computer on your network. Green
indicates that your computer is communicating at 100 Mbps; amber indicates
communication at 10 Mbps. If a LAN light is not lit for each connected Ethernet
cable, make sure that the Ethernet cable from the computer to the router is securely
attached at both ends, and that the computer is turned on.
"Restoring the Default Password and
for more information.
Figure 12 displays.
Manually Installing Your Router