Configuring Your Wireless Network; Specifying Wireless Settings; Setting Your Ssid And Wireless Security Manually - NETGEAR RangeMax WNR1000 Install Manual

This section describes additional configuration and testing for your network, after you have
performed basic installation of the N150 Wireless Router. For a wireless connection, the router
and each wireless computer must use the same SSID, also called the wireless network name, and
the same wireless security. NETGEAR strongly recommends that you use wireless security.
Indoors, computers can connect over wireless networks at a range of several hundred
feet. This can allow others outside of your immediate area to access your network.

Specifying Wireless Settings

The Wireless Settings screen lets you set your wireless network connections and the wireless
security option for your network and router. To configure the wireless network, you can either
manually specify your network name (SSID) and your wireless security settings (see
SSID and Wireless Security Manually" on page
capable, you can use Wi-Fi Protected Setup (WPS) to automatically set the SSID and implement
WPA/WPA2 security on both the router and the client device (see
to Configure Your Wireless Network" on page
If you configure the router from a wireless computer and you change the router's
SSID, channel, or security settings, you will lose your wireless connection when
you click Apply. You must then change your computer's wireless settings to match
the router's new settings. To avoid this situation, you can use a computer that is
connected to the router with an Ethernet cable.
For a complete overview of all the security configurations that can be implemented on this router,
see the online User Manual.

Setting Your SSID and Wireless Security Manually

To specify the wireless settings, you must know the following:
• SSID. The default SSID for the router is NETGEAR.
• The wireless mode (802.11g/b, or 802.11n) that each wireless adapter supports.

Configuring Your Wireless Network

Configuring Your Wireless Network
21) or, if the clients in your network are WPS
"Using Push 'N' Connect (WPS)
23).
"Setting Your
21