Section 2: Quick Guide; Default Codes; Menu Access Operation/Navigation; How To Set/Unset - Honeywell Galaxy 2 Series Installation Manual

Galaxy 2 Series Installation Manual

SECTION 2: QUICK GUIDE

How to Boot up
Wire up the keypads, address them (see Peripherals - Installation, Wiring and Addressing), then apply power
to the system. The keypads will configure and show the default banner display.

Default Codes

Default User Code: 1234
Default Engineer code: 112233

Menu Access Operation/Navigation

Only valid codes can access the Galaxy 2 Series menu options.
Type the code then press ent to access the menu.
Data entry, on both ECP and RS485 keypads, is via the 0-9 function keys and the *, # on the keypad.
The A> and <B keys are curser or scroll keys and are used to scroll through options in menus.
The ent key is used to enter a PIN code and to accept screen information.
The esc key is used to cancel or exit from the current operation.
NOTE: Users cannot view or access options for which they are not authorised.
How to get in and out of Engineer Mode
Entry to engineer mode is authorised by a user in menu option 48 = Level 3 Access. Following this the
engineer will have five minutes in which to enter his code. When the engineer code is entered four things
happen:
• All system tampers become isolated.
• All fault signalling is suppressed, and indications are silent.
• The engineer is given access to the full menu.
• The banner message is changed to indicate engineer mode.
To bring the system back out of engineer access mode and reinstate all the tampers from the banner, the
engineer enters his code but presses the esc key rather than the ent key.

How to Set/Unset

To Full Set the system, the user types their code then presses the A key.
To Part Set the system, the user types their code, presses the B key then presses the [1] key.
To Night Set the system, the user types their code, presses the B key then presses the [2] key.
To Unset the system, the user types their code then presses ent.
G a l a x y G a l a x y G a l a x y G a l a x y G a l a x y 44 44 44 44 44
09:51 09:51 SAT 01 JAN SAT 01 JAN
09:51 09:51 09:51 SAT 01 JAN SAT 01 JAN SAT 01 JAN
Quick Guide
V1.0 V1.0 V1.0 V1.0 V1.0
3