Advertisement
Oven Testing Procedures
To avoid risk of electrical shock, personal injury or death; disconnect power to range before servicing, unless
testing requires power.
Illustration
M1 Controlled
Child lockout
M1 Controlled
Diagnostic Code
Display
"Quick Test" Mode for Electronic Range Control
Follow procedure below to use the quick test mode. Entries must be made within 32 seconds of each other or the
control will exit the quick test mode.
1. Press and hold Cancel and Broil pads for 3 to 5 seconds.
2. Once the control has entered the "Quick Test" mode, release both pads.
3. Press each of the following pads indicated in the table below.
NOTE:
The first time one of the following pads is pressed it will activate the response.
The second time the pad is pressed it will deactivate the response.
NOTE:
This mode must be entered within the first 5 minutes after power up.
NOTE:
If the temperature sensor is greater than 400° F or if the temperature sensor reaches 400° F while under
test, the Quick Test mode will be disabled.
Display will indicate the following:
Key
[Bake]
[Broil]
[Keep Warm]
[Cook&Hold]
[Clean]
[Delay] (M1)
[Timer]
[Clock]
[More +]
[Less –]
[Cancel]
16026294
!
Component
Press and hold Cancel and Cook &
Hold pads for 3 to 5 seconds until
beep sounds.
To reactivate the control, press and
hold Cancel and Cook & Hold pads
for 3 to 5 seconds.
Press and hold (slew up) pad within
60 seconds of powering up the unit.
Cycle through the codes using the
(slew up) or (slew down) pads.
Bake relay activated, DLB relay activated
Broil relay activated, DLB relay activated
DLB relay activated
Last Diagnostic Code displayed
Beep sounds
EEPROM Version Number displayed
Main Code Version Number displayed
All Segments On
Even Segments On
Odd Segments On
End Factory Test Mode
WARNING
Test Procedure
Operation
4
Results
This is a safety feature that can be used
to prevent children from accidentally
programming the oven. It disables the
electronic oven control.
Child lockout features must be reset after
a power failure.
The last 5 diagnostic codes will be stored
in the non-volatile memory.
See "Description of Error Codes" for
explanation.
©2005 Maytag Services
May 2005
Advertisement
