Advertisement
Component and Oven Testing Procedures
To avoid risk of electrical shock, personal injury or death; disconnect power to range before servicing, unless
testing requires power.
Illustration
Bake element
Hi-limit temperature
switch
Cooling fan motor
Oven Control Testing Procedures
Illustration
M1 Controlled
Oven temperature
adjustment
M1 Controlled
Temperature display
M1 Controlled
Clock Display
M1 Controlled
24 Hour Clock
M1 Controlled
Factory Default
M1 Controlled
Twelve hour off
M1 Controlled
Sabbath Mode
May 2005
©2005 Maytag Services
!
Component
Disconnect wiring to element and
measure cold resistance of terminals. .......
Measure voltage at bake element ..............
Normally closed, verify operation:
Open: 208° to 222°F (98° to 105°C) .........
Closed: 156° to 174°F (69° to 79°C).........
Measure voltage ........................................
Check motor windings to ground................
Component
Press Bake pad.
Enter 550 on the digit-pad.
Immediately press and hold Bake pad
for 3 to 5 seconds.
Oven can be adjusted from -35 to +35
degrees in 5-degree increments by
pressing (slew up) or (slew down)
pads. To avoid over adjusting the
oven, move temperature 5 degrees
each time. Wait 4 seconds for the data
entry timer to expire to accept the
change. Temperature adjustment will
be retained even through a power
failure.
Press and hold Cancel and Bake
pads for 3 to 5 seconds. Press
(slew up) or (slew down) pads to
change.
Press and hold Cancel and Clock
pads for 3 to 5 seconds.
Press and hold Cancel and Delay
pads for 3 to 5 seconds. Press
(slew up) or (slew down) pads to
change.
Press and hold Cancel and Keep
Warm pads for 3 to 5 seconds until
beep sounds.
Control will automatically cancel any
cooking operation and remove all relay
drives 12 hours after the last pad
touch.
Hold Clock pad for 3 to 5 seconds to
activate Sabbath mode.
Hold Clock for 3 to 5 seconds to
disable Sabbath mode.
Desired bake function must be
initiated before entering Sabbath
mode.
WARNING
Test Procedure
Test Procedure
3
Results
Approx. 22 Ω.
240 VAC.
Infinite.
Continuity.
120 VAC.
No continuity.
RPM: 1670 to 2070
Results
While increasing or decreasing oven
temperature, this does not affect self-
cleaning temperature.
This mode enables the user to indicate
°F or °C on the display.
Allows clock to be toggled On or OFF.
Allows the time on the clock to be
toggled from 12 hour or 24 hour display.
Allows the clock to be reset to factory
settings.
See Sabbath mode to disable.
"SAb" will be displayed and flash for 5
seconds then remain on until timed-out
or cancelled.
The status "SAB" is NOT fault code 5A6.
All pad inputs are disabled except for
CANCEL and CLOCK pads.
This mode disables the normal 12 hour
shutoff to allow operation of the bake
mode for a maximum of 72 hours.
The oven light is not disabled.
16026294
Advertisement
