Range Control Panel; Setting The Clock And Timer - Maytag CHE9830BCB Repair Manual

Broil Pad Setting the Clock and Timer
Use this pad to select hroil. Two heat selections are
Clock
available for broilin_Hi and Lo. See page 12 for more
broiling information. To set the time-of-day clock:
Self Clean Pad
1. Press the CLOCK pad once. The words "SET
TIME" will flash in the display.
Press this pad to set the oven for a self-clean cycle. See
pages 14 1.5 for detailed information on the self-clean '2. Set the correct time of day' using the • and • pads.
feature. • To change the time by one minute, press either
pad onee.
Oven Stop/Cook Time Pads • To change the time in increments of i0 minutes,
These pads are used to program the oven to start and press and hold either pad.
stop automatically, either immediately or at a later time.
For detailed information on using Programmed Oven When the power is first supplied to the range or if there
Operations, see pages 12-13. has been a power failure, the display will flash. Follow
above instructions to set the clock. The clock time
Convect Pad
cannot be changed when the oven is set for a time cook
or self-clean operation. Cancel the operation to set the
Press this pad to select convection baking and roasting, clock.
Set the oven temperature by pressing the • or • pads.
See pages 10 11 for more information on convection Press the CLOCK pad to recall the time of dav when
cooking, another fimetion is displayed.
Oven Temp Pad Timer
Press this pad to seleet regular baking and roasting. Set To set the timer:
the oven temperature by pressing the • or • pads. 1. Press the TIMER pad once. The words "SET
Additional information can be found on pages i0-11. TIMER" will flash in the display:
Timer Pad 2. Set the desired time using the • and • pads.
The timer can be set from 1 minute to 9 hours, 50 • Press either pad once to change the time by 1
minutes. It will connt do_,al by seconds (when set for 1 minute (if the Timer is set for up to 1 hour), 5
minute) or minutes (when set for 2 minutes or more minutes (if Timer is set for over 1 honr) or 10
time). See below for instructions on setting the timer, minutes (if the Timer is set for over 2 hours).
• Press and hold either pad to change the time in .5
• and • Pads minute or 10 minute increments, depending npon
Press or press and hold these pads to enter the time or the time set in the display
temperature desired. These pads are also used to select
The TIMER can be set from 1 minute (0HR:01) up to 9
Hi or Lo broil, hours am150 ]ninutes (9 HR:50).
The timing operation will start automatically. Colons
will flash in the display to indicate a timing operation.
One long eontinuons beep will signal the end of the
timing operation and "End" will briefly appear in the
display. The time of day will automatically reappear in
the display. The TIMER pad does not control the
oven.
To eancel: Press the TIMER pad and hold for 3
seconds. The time of day will reappear after a slight
delay.
PAGE 6