Makita DUS108 Instruction Manual page 18

DRAINING THE TANK
NOTE: Make sure that the O-ring inside the liquid outlet cap is in place.
NOTE:
CLEANING THE TANK
NOTE:
• Wipe the outside of the tank with a clean, dry cloth.
CLEANING THE NOZZLE
• Loosen and remove the nozzle from spray wand.
•
CLEANING THE PUMP
2. Remove the spray wand from handle.
3. Drain any remaining liquid or store leftover liquid to another container to make sure the tank is empty.
4. Unscrew the red cap to open water inlet hole, and then connect the hole to the water tap. Make sure the O-ring is
placed inside the red cap. Refer to Figure 15.
adhered to the pump. Refer to Figure 16.
6. Disconnect the water tap and re-tighten the red cap. Make sure that the O-ring inside the cap is in place.
Figure 15
Figure 14
1 Red cap 2 O-ring
18 English
Figure 16
.