Makita DRC300 Usage Manual page 2

Put away the following.
Long, thin objects.
Easily-snagged objects.
Secure carts and other equipment
so that they do not move.
Check the magnetic boundary
line.
Water droplets, etc.
Peeling
Tears
If it is wet, wipe it off. If it is peeling or torn,
replace it.
We recommend stick the magnetic boundary
line to secure it.
Using the Robotic Cleaner in a Factory or Warehouse
CAUTION Precautions to prevent the robotic cleaner from falling
● If the cliff sensors are dirty or have water droplets attached due to condensation or the like, wipe them clean.
● Place obstacles with a height of 25 cm (9-7/8") or more (objects that will not move or fall over if hit by the robotic
cleaner) in areas where the robotic cleaner may fall and cause an accident.
● Refrain from using robotic cleaner on a mezzanine floor, a loft, a stairwell, a high location without walls, or a place
with a slope of 10° or more.
Place obstacles in front of gaps that are
approximately the same height as the robotic
cleaner.
20 cm (7-7/8")
*Keep the room bright when performing mapping.
Place obstacles in front of equipment with controls at
about the same height as the robotic cleaner, or
change the location of the controls.
MAKITA CORPORATION | makita.ca | 1950 FORBES STREET, WHITBY, ON. L1N 7B7
2
In large spaces, you can clean more
efficiently by dividing the space using a
magnetic boundary line (sold separately) or
obstacles with a height of 25 cm (9-7/8") or
more. You can also use the app to limit the
cleaning area.
1 2
3 1
4 5
If cleaning only visible debris, the
operation time can be extended by turning
off the vacuum fan.
x2
OFF ON
Battery workload (approximate) Battery workload (approximate)
BL1830 ×2 ... 600 m BL1830 ×2 ... 300 m
2 2
(6458 sq ft) (3229 sq ft)
BL1860 ×2 ... 1200 m BL1860 ×2 ... 600 m
2 2
(12917 sq ft) (6458 sq ft)
Registration of room information (mapping)
may fail in large spaces with no obstructions
within 11 m (36.09 ft) around the robotic
cleaner. Operate in free cleaning mode.
Free cleaning mode can be operated if there
is an obstacle within a 18 m (59.06 ft) radius
from the robotic cleaner.
When you have performed mapping, setting
continuous cleaning in the app will allow the
robotic cleaner to start continuing from the
previous cleaning if it stopped before
cleaning the entire area due to insufficient
battery power.