Makita RT001GZ18 Instruction Manual page 19

2.
Loosen the clamp screw and adjust the distance
between the trimmer bit and the trimmer guide by turning
the adjusting screw (1 mm per turn). At the desired distance,
tighten the clamp screw to secure the trimmer guide.
1
2
Fig.57
► 1. Adjusting screw 2. Clamp screw
3. Move the tool with the guide roller riding the side
of the workpiece.
1
Fig.58
► 1. Workpiece 2. Trimmer bit 3. Guide roller
Using the tool with the tilt base
The tilt base is used for trimming the edge of laminate
sheet or similar materials.
The tilt base is convenient for chamfering. Loosen the
wing screws, then tilt the tool at the desired angle, and
then tighten the wing screws.
Firmly clamp a straight board to the workpiece and use
it as a guide against the tilt base. Feed the tool in the
direction of the arrow.
Fig.59
► 1. Wing screw
Using the tilt base plate with the
trimmer base
To use the trimmer base with a square base plate,
remove the base plate from the tilt base, and then
attach it to the trimmer base.
Fig.60
► 1. Tilt base plate 2. Trimmer base plate
2
NOTICE:
installing the tilt base plate. The screws on the
tilt base are shorter than the screws on the trimmer
base.
Using the tool with the offset base
3
The offset base is used for trimming the edge of lami-
nate sheet or similar materials. The offset base is con-
venient for work in a tight area.
Fig.61
1
19 ENGLISH
1 2
Use screws on the trimmer base when