Advertisement
Quick Links
Advertisement
Related Manuals for HIKVISION AE-VC154T-IT
Summary of Contents for HIKVISION AE-VC154T-IT
- Page 1 DBA Vehicle-Mounted Camera User Manual UD13292B...
- Page 2 Hikvision marks are the property of Hikvision and are registered trademarks or the subject of applications for the same by Hikvision and/or its affiliates. Other trademarks mentioned in this manual are the properties of their respective owners. No right of license is given to use such trademarks without express permission.
- Page 3 Regulatory Information FCC Information FCC compliance: This equipment has been tested and found to comply with the limits for a digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
- Page 4 Safety Instruction These instructions are intended to ensure that user can use the product correctly to avoid danger or property loss. The precaution measure is divided into “Warnings” and “Cautions” Warnings: Serious injury or death may occur if any of the warnings are neglected.
- Page 5 (which is not a malfunction), and affect the endurance of sensor at the same time. The sensor may be burned out by a laser beam, so � when any laser equipment is in using, make sure that the surface of sensor will not be exposed to the laser beam.
-
Page 6: Product Features
1 Introduction 1.1 Product Features This series of camera adopts new generation sensor with high sensitivity and advanced circuit design technology. It features high resolution, low image distortion and low noise, etc., which makes it suitable for monitoring system and image processing system. The main features are as follows: High performance CMOS sensor �... -
Page 7: Installation
4-Pin Din Connetor Interface Interfaces of 4-Pin Din Connector The power supply for the camera is 6 VDC to 16 VDC. 2 Installation Before you start: Please make sure that the device in the package is in � good condition and all the assembly parts are included. - Page 8 1. Clean the mounting surface with a mixture of isopropyl and water. Choose a mounting position that camera can aim at the driver. 2. Peal the paster of the mounting base. Peal the Paster 3. Paste the camera onto mounting position. Paste the Camera 4.