Quick Reference - Makita DTD172ZJ Instruction Manual

Quick reference

The following table shows the functions of the quick mode-switching button.
indicates the quick mode-switching button.
Button(s) / Purpose
(When quick mode-switching function
is OFF)
Changing the impact force by the quick
mode-switching button
(When quick mode-switching function
is ON)
Switching to the registered application
mode
Registering the application mode
Erasing the registered application mode
Disabling/resuming the quick
mode-switching button
: The lamp is blinking.
Changing the impact force
You can change the impact force in four steps: 4 (max), 3 (hard), 2 (medium), and 1 (soft).
This allows a tightening suitable to the work.
The level of impact force changes every time you press the button
You can change the impact force within approximately one minute after releasing the switch trigger.
NOTE: You can extend the time to change the impact force approximately one minute if you press the but-
ton , , or the quick mode-switching button.
► Fig.9: 1. Button
Application mode
(Impact force grade
displayed on panel)
4 (Max)
3 (Hard)
Press and hold (each button)
Press and hold (each button)
Press and hold (each button)
Maximum blows
-1
3,800 min (/min) Tightening with the maximum force
and speed.
-1
3,600 min (/min) Tightening with less force and speed
than Max mode (easier to control than
Max mode).
Action
Press
Press
or the quick mode-switching button.
Purpose
10 ENGLISH
How to confirm
The front lamps on the tool flash once.
The front lamps on the tool flash once.
Example: Wood mode is registered
The lamp of desired application mode
blinks.
All impact force grade lamps blink.
All lamps on the panel blink.
Example of application
Driving screws to underwork materi-
als, tightening long screws or bolts.
Driving screws to underwork materi-
als, tightening bolts.