Unit Identification Plates - Honeywell SYA14 Series Manual

Figure 2-1 Control and Sensing Unit Compatibility
Each sensing unit must be connected to a specific control unit per table 2-1.
INCOMPATIBILITY OF FF-LS SERIES SAFETY CONTROL UNITS
DO NOT connect a different control unit other than the one specified (see table below) to the sensing units.
Failure to comply with these instructions could result in death or serious injury.
Table 2-1 Control Unit and Sensing Units Compatibility
Control unit 30 mm Resolution Sensing Unit
FF-LS08C
FF-LS16C
FF-LS24C
FF-LS32C
FF-LS40C
FF-LS48C
FF-LS56C
FF-LS64C

2.2.3 Unit Identification Plates

Figure 2-2 Control Unit Rating and Approvals Plate
11
FF-LS082802362A/B
FF-LS162804602A/B
FF-LS242806842A/B
FF-LS322809082A/B
FF-LS402811322A/B
FF-LS482813562A/B
FF-LS562815802A/B
FF-LS642818042A/B
14 mm Resolution Sensing Unit
--
FF-LS16141962A/B
--
FF-LS32143782A/B
--
FF-LS48145612A/B
--
FF-LS64147442A/B
Red label indicates the
number of beams. This
number must be the
same number that is on
the sensing units red
label.
107022-14 EN FR26 GLO 0100 Printed in Germany
Number of Beams
08
16
24
32
40
48
56
64