Honeywell SYA14 Series Manual page 152

FF-SB Installation Manual
9. Place replacement module in position and plug the flat cable connector into the socket.
Retain it with two moving parts.
10. Position all the optical modules on the plastic support and ensure they are correctly
aligned. Using a Philip's screwdriver, install and tighten all screws.
11. Aligning the slots in the plastic support with those on the housing, gently push the optical
controller module into the housing.
12. Aligning the straight ends of the retaining rods with the slot next to the lens holders, slide
the rods in (see figure 4-11) and turn them to secure into position. The retaining rod ends
must be vertical to close the unit.
13. Perform the Power Supply Module Replacement procedure.
For application help: call 1-800-537-6945
Jumper
Honeywell • MICRO SWITCH Sensing and Control 71