Figure 6-14: Wireless Bridge Diagram - Linksys WAP54GPE User Manual

Wireless-G Exterior Access Point
Wireless Bridge. This mode connects two physically separated wired networks with two access points. If you
are trying to create a wireless connection between two wired networks, select Wireless Bridge. and enter the
local MAC addresses of the wireless bridges/access points in the MAC 1-3 fields. If you do not know a wireless
bridge/access points's MAC address, click the Site Survey button. Select the wireless bridges/access points you
want to use and click the Apply button. Then click the Close button to return to the AP Mode screen. If you do not
see the wireless bridge/access point you want, click the Refresh button to run another site survey. The remote
wireless bridges/access points also need to be set to Wireless Bridge mode.
Change these settings as described here and click Save Settings to apply your changes, or click Cancel
Changes to cancel your changes. Help information is displayed on the right-hand side of the screen, and click
More for additional details.
Chapter 6: Configuring the Wireless-G Exterior Access Point
The AP Mode Tab

Figure 6-14: Wireless Bridge Diagram

IMPORTANT: In Wireless Bridge mode, the Access
Point can ONLY be accessed by another access point
in Wireless Bridge mode. In order for your other
wireless devices to access the Access Point, you
must reset it to Access Point mode. The two modes
are mutually exclusive.
29