Chapter 4: Connecting The Wireless-G Exterior Access Point; Overview; Hardware Installation; Figure 4-1: Mark The Locations Of The Two Wall-Mount Slots - Linksys WAP54GPE User Manual

Wireless-G Exterior Access Point

Chapter 4: Connecting the Wireless-G Exterior Access Point

Overview

This chapter explains how to mount and connect the Access Point.

Hardware Installation

1. Locate an optimum location for the Access Point.
2. Use the mounting plate as a template. On the wall you have chosen, mark the locations of the two wall-mount
slots at the bottom of the mounting plate.
3. Attach two screws (not included) to the wall, so that the Access Point's wall-mount slots line up with the two
screws.
4. Use four screws (included with the Access Point) to attach the mounting plate to the back panel of the Access
Point.
5. Connect the included Category 5e Ethernet network cable to the Ethernet network port of the Access Point.
Then screw the connector cap tightly onto the port, so the Access Point has a water-resistant seal.
6. If you want to connect the optional, high-gain external antenna, unscrew the cap protecting the Type-N
antenna port. Then connect your antenna to this port.
Chapter 4: Connecting the Wireless-G Exterior Access Point
Overview
hardware: the physical aspect of
computers, telecommunications, and
other information technology devices.

Figure 4-1: Mark the Locations of the Two Wall-Mount Slots

Figure 4-2: Attach the Mounting Plate

8