Table of Contents
Advertisement
1
2
012585
Loosen the hex socket bolt securing the guide fence
using the hex wrench.
Lower the handle fully and lock it in the lowered
position by pushing in the stopper pin. Square the
side of the blade with the face of the guide fence
using a triangular rule, try-square, etc. Then
securely tighten the hex socket bolt on the guide
fence in order starting from the right side.
1
002209
1
2
003942
Make sure that the pointer points to 0° on the miter
scale. If the pointer does not point to 0°, loosen the
screw which secures the pointer and adjust the
pointer so that it will point to 0°.
2.
Bevel angle
(1)
0° bevel angle
Push the carriage toward the guide fence and
tighten two clamp screws to secure the
carriage. Lower the handle fully and lock it in
the lowered position by pushing in the stopper
pin.
1. Guide fence
2. Hex socket bolt
1. Triangular rule
1. Screw
2. Miter scale
3. Pointer
3
2
012589
Loosen the lever at the rear of the tool.
Turn the 0° bevel angle adjusting bolt (lower
bolt) on the right side of the arm two or three
revolutions counterclockwise to tilt the blade
to the right.
1
001819
Carefully square the side of the blade with the
top surface of the turn base using the
triangular rule, try-square, etc. by turning the
0° bevel angle adjusting bolt clockwise. Then
tighten the lever securely.
1
2
011306
Make sure that the pointer on the arm point to
0° on the bevel scale on the arm holder. If it
does not point to 0°, loosen the screw which
secures the pointer and adjust the pointer so
that it will point to 0°.
(2) 45° bevel angle
012590
18
1. Lever
1
2. Arm holder
3. 0 ﾟ degree
bevel angle
adjusting bolt
4. Arm
5. Release button
5
4
3
1. Triangular rule
2. Saw blade
3. Top surface of
2
turn table
3
1. Bevel scale
3
2. Pointer
3. Screw
1. Left 45 ﾟ bevel
angle adjusting
bolt
1
Advertisement
Table of Contents
