Table of Contents
Advertisement
Installing or removing saw blade
1
011300
WARNING:
Always be sure that the tool is switched off and
•
the
battery cartridge is
installing or removing the blade. Accidental start
up of the tool may result in serious personal injury.
CAUTION:
Use only the Makita hex wrench provided to install
•
or remove the blade. Failure to do so may result in
overtightening or insufficient tightening of the hex
socket bolt. This could cause an injury.
Lock the handle in the raised position by pushing in the
stopper pin.
1
2
3
4
012586
To remove the blade, use the hex wrench to loosen the
hex socket bolt holding the center cover by turning it
counterclockwise. Raise the blade guard and center
cover.
1
2
3
4
012587
Press the shaft lock to lock the spindle and use the hex
wrench to loosen the hex socket bolt clockwise. Then
remove the hex socket bolt, outer flange and blade.
NOTE:
If the inner flange is removed, install it on the
•
spindle with its blade mounting part facing the blade.
1. Stopper pin
removed
before
1. Center cover
2. Hex socket bolt
3. Hex wrench
4. Safety cover
1. Shaft lock
2. Arrow
3. Blade case
4. Hex wrench
5. Hex socket bolt
5
If the flange is installed incorrectly the flange will
rub against the machine.
2
1
4
015779
For tool with the inner flange for other than
20 mm hole-diameter saw blade
(Country specific)
The inner flange has a certain diameter of a blade
mounting part on one side of it and a different diameter of
blade mounting part on the other side. Choose a correct
side on which blade mounting part fits into the saw blade
hole perfectly.
2
1
4
015663
CAUTION:
Make sure that the blade mounting part "a" on the
•
inner flange that is positioned outside fits into the
saw blade hole "a" perfectly. Mounting the blade on
the wrong side can result in the dangerous
vibration.
1
2
011244
To install the blade, mount it carefully onto the spindle,
making sure that the direction of the arrow on the surface
of the blade matches the direction of the arrow on the
blade case. Install the outer flange and hex socket bolt,
and then use the hex wrench to tighten the hex socket
bolt (left-handed) securely counterclockwise while
pressing the shaft lock.
11
1. Outer flange
3
2. Saw blade
3. Inner flange
4. Hex socket bolt
(left-handed)
5. Spindle
6. Blade mounting
5
part
6
1. Outer flange
3
2. Saw blade
3. Inner flange
4. Hex socket bolt
(left-handed)
5. Spindle
6. Blade mounting
5
part
6
1. Blade case
3 4
2. Arrow
3. Arrow
4. Saw blade
Advertisement
Table of Contents
