Black & Decker BCD900 Manual page 7

of any operation with this tool other than those
recommended in this instruction manual may present a
risk of personal injury and/or damage to property.
Use a face or dust mask whenever the operations may
u
produce dust or flying particles.
Safety of others
This appliance is not intended for use by persons
u
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the appliance by a person responsible
for their safety.
Children should be supervised to ensure that they do not
u
play with the appliance.
Residual risks.
Additional residual risks may arise when using the tool which
may not be included in the enclosed safety warnings. These
risks can arise from misuse, prolonged use etc.
Even with the application of the relevant safety regulations
and the implementation of safety devices, certain residual
risks can not be avoided. These include:
Injuries caused by touching any rotating/moving parts.
u
Injuries caused when changing any parts, blades or
u
accessories.
Injuries caused by prolonged use of a tool. When using any
u
tool for prolonged periods ensure you take regular breaks.
Impairment of hearing.
u
Health hazards caused by breathing dust developed when
u
using your tool (example:- working with wood, especially
oak, beech and MDF.)
Vibration
The declared vibration emission values stated in the technical
data and the declaration of conformity have been measured in
accordance with a standard test method provided by EN62841
and may be used for comparing one tool with another.
The declared vibration emission value may also be used in a
@
preliminary assessment of exposure.
WARNING! The vibration emission value during actual
use of the power tool can differ from the declared value
depending on the ways in which the tool is used. The
vibration level may increase above the level stated.
When assessing vibration exposure to determine safety
measures required by 2002/44/EC to protect persons regularly
using power tools in employment, an estimation of vibration
exposure should consider, the actual conditions of use and the
way the tool is used, including taking account of all parts of the
operating cycle such as the times when the tool is switched off
and when it is running idle in addition to the trigger time.
(Original instructions)
Labels on tool
The following symbols are shown on the tool along with the
date code:
a
WARNING! To reduce the risk of injury, the user
must read the instruction manual.
g
Wear ear protectors with Rotary hammers.
Exposure to noise can cause hearing loss.
n
Do not stare at operating lamp
Additional safety instructions for batteries and
chargers
Batteries
Never attempt to open for any reason.
u
Do not expose the battery to water.
u
Do not expose the battery to heat.
u
Do not store in locations where the temperature may exceed
u
40 °C.
Charge only at ambient temperatures between 10 °C and
u
40 °C.
Charge only using the charger provided with the appliance/
u
tool.
When disposing of batteries, follow the instructions given in
u
the section "Protecting the environment".
Do not damage/deform the battery pack either by puncture or
u
impact, as this may create a risk of injury and fire.
Do not charge damaged batteries.
u
Under extreme conditions, battery leakage may occur. When
u
you notice liquid on the batteries carefully wipe the liquid off
using a cloth. Avoid skin contact.
@
In case of skin or eye contact, follow the instructions below.
u
WARNING! The battery fluid may cause personal
injury or damage to property. In case of skin contact,
immediately rinse with water. If redness, pain or
irritation occurs seek medical attention. In case of
eye contact, rinse immediately with clean water and
seek medical attention.
Chargers
Your charger has been designed for a specific voltage. Always
check that the mains voltage corresponds to the voltage on
@
the rating plate.
WARNING! Never attempt to replace the charger unit
with a regular mains plug.
Use your charger only to charge the battery in the tool with
u
which it was supplied. Other batteries could burst, causing
personal injury and damage.
Never attempt to charge non-rechargeable batteries.
u
ENGLISH
7