Black & Decker BHSB315J Original Instructions Manual page 7

Using the wrong charger could result
in an electric shock or overheating of
the battery.
When disposing of batteries, follow
u
the instructions given in the section
"Protecting the environment".
Do not damage/deform the battery
u
pack either by puncture or impact, as
this may create a risk of injury and fire.
Do not charge damaged batteries.
u
Under extreme conditions, battery
u
leakage may occur. When you notice
liquid on the batteries carefully wipe
the liquid off using a cloth. Avoid skin
contact.
In case of skin or eye contact, follow
u
the instructions below.
Warning! The battery fluid may cause
personal injury or damage to property. In
case of skin contact, immediately rinse
with water. If redness, pain or irritation
occurs seek medical attention. In case of
eye contact, rinse immediately with clean
water and seek medical attention.
Chargers
Your charger has been designed for a
specific voltage. Always check that the
mains voltage corresponds to the voltage
on the rating plate and the information in
the technical data table.
Warning! Never attempt to replace the
charger unit with a regular mains plug.
Use your BLACK+DECKER charger
u
only to charge the battery in the appli-
ance/tool with which it was supplied.
Other batteries could burst, causing
personal injury and damage.
(Original instructions)
Never attempt to charge nonrecharge-
u
able batteries.
If the supply cord is damaged, it must
u
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
The appliance/tool/battery must be
u
placed in a well ventilated area when
charging.
Electrical safety
Your charger has been designed for a
specific voltage. Always check that the
mains voltage corresponds to the volt-
age on the rating plate. Never attempt
to replace the charger unit with a regular
mains plug.
Symbols on the charger
)
Read all of this manual carefully
before using the appliance.
This tool is double insulated;
#
therefore no earth wire is
required. Always check that the
power supply corresponds to
$
the voltage on the rating plate.
The charging base is intended
for indoor use only.
Labels on appliance
The following symbols appear on this appliance along with the
date code:
Use with charger
QW = S010QV1400040 /S003AQV1500015
S003AQ 15
QW = S010QV1400040
GB = S010**1400040 /
GB = S010QB1400040 / S003AQB1500015
S003**1500015
ENGLISH
7