Honeywell 7800 Series Manual page 31

TABLE 6—SEQUENCE AND STATUS HOLD INFORMATION (continued).
NOTE: Normal sequences are in bold type, while abnormal sequences are not in bold type.
Sequence
RUN
RESET/ALARM TEST
Explanation
The LEDs indicate the burner status, POWER, PILOT,
FLAME and MAIN, which is entered when the Start Switch
is released.
The LED indicates the burner status, POWER and ALARM.
This condition indicates that the reset pushbutton is pressed. If
it is held for more than four seconds, the alarm output is
energized.
31
RM7885A
TROUBLESHOOTING
65-0107