Maintenance; Optional Accessories - Makita 3710 Instruction Manual

Fig.17
NOTE:
Circles between 172 mm and 186 mm in radius
•
cannot be cut using this guide.
Align the center hole in the straight guide with the center
of the circle to be cut. Drive a nail less than 6 mm in
diameter into the center hole to secure the straight
guide. Pivot the tool around the nail in clockwise
direction.
Fig.18
Trimmer guide
Fig.19
Trimming, curved cuts in veneers for furniture and the
like can be done easily with the trimmer guide. The
guide roller rides the curve and assures a fine cut.
Loosen the wing bolts and secure the tool base
horizontally. Install the trimmer guide on the tool base
with the clamp screw (A). Loosen the clamp screw (B)
and adjust the distance between the bit and the trimmer
guide by turning the adjusting screw (1 mm per turn). At
the desired distance, tighten the clamp screw (B) to
secure the trimmer guide in place.
Fig.20
When cutting, move the tool with the guide roller riding
the side of the workpiece.
Fig.21

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
Replacing carbon brushes
Fig.22
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
Fig.23
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.

OPTIONAL ACCESSORIES

CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Router bits
Straight bit
Fig.24
D
20 6
20E 1/4"
8 6
8E 1/4"
6 6
6E 1/4"
006485
"U"Grooving bit
Fig.25
D
6 6
6E 1/4"
006486
"V"Grooving bit
Fig.26
D A
1/4" 20
006454
Drill point flush trimming bit
Fig.27
D
6 6
6E 1/4"
006487
Drill point double flush trimming bit
Fig.28
D
6 6
6E 1/4"
006488
9
or attachments
Only use accessory or
A L 1
20 50
8 50
6 50
A L 1 L 2
6 60 28
mm
L 1 L 2
50 15 90
A L 1 L 2
6 60 18
A L 1 L 2 L 3
6 70 40 12
are
mm
L 2
15
18
18
mm
R
3
mm
L 3
28
mm
L 4
14