Makita 2012NB Instruction Manual page 5

Intended use
The tool is intended for planing wood.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause
voltage fluctuations. The operation of this device under
unfavorable mains conditions can have adverse effects
to the operation of other equipment. With a mains
impedance equal or less than 0.36 Ohms it can be
presumed that there will be no negative effects. The
mains socket used for this device must be protected
with a fuse or protective circuit breaker having slow
tripping characteristics.
Noise
The typical A-weighted
according to EN61029:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Wear ear protection
For European countries only
EC Declaration of Conformity
We Makita Corporation
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
Thicknesser
Model No./ Type: 2012NB
are of series production and
Conforms to the following European Directives:
2006/42/EC
And are manufactured in accordance with the following
standard or standardized documents:
EN61029
The technical documentation is kept by:
Makita International Europe Ltd.
Technical Department,
Michigan Drive, Tongwell,
Milton Keynes, Bucks MK15 8JD, England
ENE001-1
ENF002-1
ENF100-1
ENG905-1
noise level determined
) : 85 dB (A)
pA
) : 98 dB (A)
WA
ENH037-5
as the responsible
000230
Makita Corporation
3-11-8, Sumiyoshi-cho,
Anjo, Aichi, 446-8502, JAPAN
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for
future reference.
THICKNESSER SAFETY
WARNINGS
1. Wear eye protection.
2. Wear suitable personal protective equipment
when necessary, such as hearing protection
(ear plugs), respiratory protection (dust mask)
and gloves when handling planer blades and
rough material.
3. Do not use the tool in the presence of
flammable liquids or gases.
4. Make sure that all covers are installed in place
before operation.
5. Handle the blades very carefully.
6. Check the blades carefully for cracks or
damage before operation. Replace cracked or
damaged blades immediately.
7. Tighten the blade installation bolts securely.
8. Remove nails and clean the workpiece before
cutting. Nail, sand or foreign matter can cause
blade damage.
9. Do not remove chips from the chip chute
when the motor is running. Clean out chips
after the blades come to a complete stop.
Always use a stick etc. when cleaning them
out.
10. Do not leave the tool running.
11. Do not abuse cord. Never yank cord to
disconnect it from the receptacle. Keep cord
away from heat, oil, water and sharp edges.
12. The tool should only be used for wood and
similar materials.
13. Never carry out stopped work (i.e. any cut
which does not involve the full work piece
length).
5
19.2.2013
Tomoyasu Kato
Director
GEA010-1
GEB066-2