Motorola APEX1000 Installation And Operation Manual page 289

Output Transport Stream Utilization window field definitions
Item
Output Transport Stream
Output Stream Status
Output Overflow Status
Output Threshold Status
Data Rate (Mbps) –
Current
Data Rate (Mbps) –
Average
Data Rate (Mbps) – Peak
Data Rate (Mbps) –
Minimum
Status • Reports
APEX1000 All-Purpose Edge QAM Software Version 2.4.x • Installation and Operation Manual
573408-001-a
Definition
The transport stream number associated to an output interface port.
Summary of the possible alarms associated with an output stream, such
as:
•
Output Utilization Threshold
•
Output Overflow
The highest current fault is indicated by each LED. The alarm indications
are as follows:
•
Green – no alarm
•
Gray – cause of alarm is indeterminate
•
Yellow – warning
•
Blue – minor
•
Magenta – major
•
Red – critical
If an LED alarm indication is active, display the
determine which of the above Output Transport Stream alarms is
causing the event.
•
This LED is red if an overflow error occurred at least once during this
sampling interval.
•
When green, it indicates no output overflow error occurred.
An output overflow indicates that the input stream data rate is either
greater than the output stream data rate, or the input stream has had a
sudden burst (a sudden increase in the input data rate).
Caution: Input streams that are bursty can cause the APEX1000 to
overflow and will result in the dropping of output packets.
This LED is red if a Threshold Reached Error occurred at least once
during this sampling interval.
When green, it indicates No Threshold Reached error occurred.
Current data rate of most recently taken sample (1 – 16 seconds
depending on the number of streams being monitored).
Average utilization over this sampling interval (in bps).
This is the average data rate over the last 15 minutes (sampling interval
is a sliding 15 minute interval).
Peak utilization for a sample during this sampling interval (in bps).
This is the peak data rate over the last 15 minutes (sampling interval is a
sliding 15 minute interval).
Minimum utilization for a sample during this sampling interval (in bps).
This is the minimum data rate over the last 15 minutes (sampling interval
is a sliding 15 minute interval).
B
Alarms window to
271