Motorola APEX1000 Installation And Operation Manual page 143

Item
Encryption
Mode
CCI level
APS level
Common Tier
CIT Enable
Status
Configuration • Encryption Configuration
APEX1000 All-Purpose Edge QAM Software Version 2.4.x • Installation and Operation Manual
573408-001-a
CTE tab field definitions
Definition/Range
Use to configure the global encryption mode that the APEX attempts to use to
encrypt output programs.
Values are:
•
Full – The APEX attempts to use Full encryption. The APEX tries to get Entitlement
Management Messages from an EMM server, configured through the RDS tab.
(Full encryption requires the APEX to have received valid EMMs from an RDS.)
•
FWK (Fixed Working Key) – The APEX uses Fixed Working Key encryption.
•
FPK (Fixed Program Key) – The APEX uses Fixed Program Key encryption.
•
Clear – The APEX performs no encryption of output programs, and does not insert
Entitlement Control Messages (ECM) into the output transport stream.
The default value is Full.
Use to configure Copy Control Information Level.
Values are:
•
Not Defined – Set-top box applications can configure the CCI Level.
•
Copy Freely – No restriction on program copying.
•
Copy Once – Program can be copied only once.
•
Copy Never – Program can never be copied.
•
No More Copies – Maximum number of copies has been reached.
The default value is Copy Never.
Use to configure Analog Protection System Level.
Values are:
•
Not Defined – Set-top box applications can configure APS.
•
Off – No analog protection.
•
Split Burst Off – Split burst off.
•
Split Burst 2 Line – 2 line split burst on.
•
Split Burst 4 Line – 4 line split burst on.
The default value is Off.
Use to configure the common tier associated with all QAMs operating with CTE
enabled.
The default value is 257.
Use to configure the Constrained Image Trigger setting.
Values are:
•
Enabled – The set-top box is notified to not allow a high quality digital output unless
the receiving device also adheres to CIT processing.
•
Disabled – CIT processing is not used.
The default value is Disabled.
Note: If the APS level is Not Defined, the CIT Setting has no effect.
Opens the RDS Status window.
B
125