Smeg GW2145 User Manual page 42

Set
PARAMETER
Residual filter hours (for GW4060, GW4190)
The parameter indicates, to the nearest ten, the number
of absolute filter hours left before the maintenance
-8
message appears. The initial default setting is 500. (e.g.
the display shows "-8:50"). The value can be reset by an
authorised engineer.
Residual cycles before maintenance
Indicates, to the nearest ten, the number of cycles left
-9 before the maintenance message appears. The initial
default setting is 900 (e.g. "-9:90").
The value can be reset by an authorised engineer.
Power Supply
The parameter indicates whether the connection is:
- single-phase: parameter setting "1"
- three-phase: parameter setting "3"
-A
N.B.: the value "3" refers to both 400V 3N~ / 50 Hz and
230V 3~ / 50Hz connections.
Warning: this parameter is only used for the correct
setting of times remaining.
Memory Data Overwriting
- Overwriting enabled: parameter setting "1"
- Overwriting disabled: parameter setting "0"
The parameter refers to whether or not the device's
internal memory, which keeps a record of all the cycles
performed and the alarms which have occurred, can be
-b overwritten.
WARNING
If overwriting is disabled, alarm AF:91 is triggered once the
memory is full. In this case the appliance will not perform
any more cycles until the data from the memory are
downloaded; this can only be done using the TRACELOG
software.
Powder dispenser Presence
(Parameter Introduced from the Main Firmware version
1.11.0.33) Parameter for use by authorized technicians
only.
This parameter is available only on certain models, where
the detergent dispenser DD is installed on the inner door.
-C It can assume the following values:
"-C: dd", it means presence and activation of the dispenser
powder (DD), it is neglected the dosage set by parameter
P1: "Set -1".
"-C: P1" for the presence of the peristaltic pump P1. The
dosage of the detergent is determined by the value
assigned to the parameter "Set -1".
User Manual
DESCRIPTION
GW2145 - GW1160 - GW4060 - GW4190
POSSIBLE USER ACTION
With set parameter
"-d=0"
Display Only Display Only
Display Only Display Only
Display Only Display Only
Display and Display and
Modification Modification
Display Only Display Only
Page 42 - 86
With set
parameter
"-d=1"